AB Nightvision RVM-14 Bridge

RVM-14 Bridge Mount will allow users to bridge two RVM-14’s together to be used a bino setup.  The bridge arranges the RVM-14 in the same vertical orientation.  The arms can also be easily removed for single mono use.  Both the Arm and the Bridge are articulating.  

NOTE:  This bridge will only work with the RVM-14 as it uses a proprietary interface.

BRIDGE / ARM OPERATION:

• To connect the Arm or Bridge to the monocular, first ensure that the Latch Screw is fully retracted by rotating it counterclockwise until it stops.
• Slide the Mounting Shoe of the Arm or Bridge onto the Dovetail Mount of the Mono.
• Engage the Latch Screw by turning it clockwise until it stops.  Ensure that the Latch Screw is properly engaged by attempting to slide the Mounting Shoe.  It should not move.
• Remove the Arm or Bridge by retracting the Latch Screw fully counterclockwise and then sliding the Mounting Shoe off of the Dovetail Mount.
• To adjust the pivot tension of the Arm or Bridge use a coin in either end of the Tension Bolt to tighten or loosen as desired.